I am trying to establish connection with the codrone using python but I am usually failing for some reason. I follow the steps correctly and the BLE board starts out blinking red and the codrone starts out blinking green. I then run my code and then my BLE board turns purple instead of green and my codrone is now solid green. I believe the drone is connecting to the controller instead of my laptop and that is the reason causing the problem. My code executes with a false output. Please help as i cannot fix this problem. Thanks
Posts made by aaditpanchal
CoDrone pair problems
CoDrone Pro with Python
I am trying to learn CoDrone with Python but whenever i try pairing Codrone from my laptop I am getting a weird error message.
I am following steps from this page.
This is a picture of the error message
CoDrone wont hover properly
I recently have bought a codrone. I am just testing it out using the controller and one difficulty i have been having is that the codrone will not hover. It keeps on bouncing to the ground even after i checked and clean all propellers. But if the codrone does hover then another thing i have noticed is that i have to push my controller's right stick forward and to the right quite a bit to make sure the codrone stays in place. I am thinking that these are calibration issues and I tried clicking on the link that would help me solve this problem but the site is dead. I think that the trim function can help solve my problems but the information about this function is very vague. Please help.