Hello, I'm still a newbie at the CoDrone programming so this may be a simple question for others. What command can I use so the CoDrone will land softly?
Hello, I've been charging the (Byrobot) battery for the CoDrone QuadCopter for over 40 minutes and the two red LEDS are still on. The video on the web says they will turn off when charged. I'm worried. Is this normal to take over 40-minutes?
Hello, I am a newbie with the CoDrone, just received it last week and have many questions. I would like to know if there are schematics for the ROBOLINK (BLE) board and the Smart Inventor V2+ board? Is the micro controller on the the Smart board the same as the micro controller found on the Arduino board? I'm assuming the micro controller is on the Smart board and not the RoboLink board. Next, if the micro controller is on the Smart board is it being programmed if I connect the USB cable to the BLE board? I notice that on the BLE board is a marking near the white connector 5V, RX, TX, GND so there must be some link to the Smart board, how does this work? What is the communication protocol? Is that a UART? I would like to learn what the chips do on the BLE board.
Curious wannabe engineer,
Looks like your connection to Robolink community was lost, please wait while we try to reconnect.